Enermax Infiniti two beeps

machomama — Tue, 13 May 2014 22:43:29 +0800

Hi fellow techies,
Posting here just to seek some advice on a matter I recently came across. It’s a PSU gone dead issue I think but just thought of getting some input first before I dump the PSU.
It’s an ENERMAX INFINITI 720 – a reliable unit that worked well for yeas 24/7 most of the time. Problem started a few days ago after awaking the PC from SLEEP. The PSU just beeped continuously. Continuous 2 beeps in 2 second intervals, non stop. You press the reset button next to the LED at the back, the beeping stops. But still no action from the PSU. Nothing happens. The PSU fan doesn’t rotate. What I notice is the Amber LED (on standby) goes to Green for a second or two, the stays a continous RED (with the Beeps). I’ve read a few forums, it states that the PSU is in "Protection mode". The Manual says that too. Unless something is shorting out usually means the PSU is dead. I didn’t mess around with the internals of the PC. It’s pretty difficult to short on a SATA, MOLEX possibility is there. Hooked the PSU up with another working MoBo (PC sysytem) - same symptoms. Lightning maybe and the PSU (being at the forefront) took the brunt of it to save the rest of the gang members (MoBo, CPU, RAMs, HDs, Graphics….). Some may say - fine just replace the PSU but for me it’s no ordinary PSU, cost me quite a bit for this fella and hate to see it just go by. I’ve since replaced the PC’s PSU with another ENERMAX, an older Liberty - these I see haven’t caused me any issues (touch wood). Thus the isolation troubleshoot proves the PSU is the culprit.
Warranty is probably out but am wondering if there’s anyone (or shops) out there that know how to get it back working.
Thanks :-)

iPhone4 call log empty/blank

machomama — Mon, 18 Oct 2010 11:34:16 +0800

hi members....
title : iPhone4 call log empty
Wondering if anyone faced this problem about the iPhone4 call log being empty / blank.

if you go Under PHONE
in RECENTS
All & Missed - all empty / blank
you make a call, receive a call, miss a call - not registered in the phone as it normally should.
it's a known problem apparently : http://discussions.info.apple.com/message....sageID=11789556

Just wondering if anyone here faced the same issues here and managed to overcome it.

Apparently if you restore the phone as a new one, don't restore from backup that is, you wll not face this issue.
Then again i know from colleagues who did the restore from backup with no issues whatsoever.
If restore from new then you tend to lose all other info.

thanks / cheers

[addedon]October 19, 2010, 2:57 pm[/addedon]my bad
posted this thread on the wrong forum la i think.....just saw the Apple Byte - iPhone forum.....will post this there, cheers

Lowyat.NET: Latest topics by machomama

Enermax Infiniti two beeps

iPhone4 call log empty/blank